How to restore a bricked TellStick Net v2, TellStick ZNet Lite (v1), or TellStick ZNet Lite v2

Did something happen during a firmware upgrade of your TellStick? And now it won't start again?
Don't worry! You can probably restore it again yourself.

If something goes wrong while upgrading the firmware in the TellStick, you'll need to put it into failsafe mode. It will then start a web browser at ip address 192.168.97.60 and it's possible to upload a new firmware there. You will need to join the same network on your computer and upload the firmware.

Please note: It's very important that you download the correct firmware for your product!
The firmware can be downloaded here:

TellStick Net v2:
​http://fw.telldus.com/tellstick-net-v2/tellstick-net-v2-1.3.2.bin

TellStick ZNet Lite (v1):
​http://fw.telldus.com/tellstick-znet-lite/tellstick-znet-lite-1.3.2.bin

TellStick ZNet Lite v2:
​http://fw.telldus.com/tellstick-znet-lite-v2/tellstick-znet-lite-v2-1.3.2.bin

Linux

Under construction!

Disconnect the power to TellStick
Press and hold the button next to the USB-connector, using a paperclip or other sharp object.
Connect the power again.
The middle LED should now flash four times. First flash should be longer and then three shorter flashes. Release the button after the fourth flash.
The middle LED will now confirm by flashing fast for one second.

Join the sub-network by adding an IP alias. Type the command:
sudo ifconfig eth0:0 192.168.97.6
Replace eth0 with the interface you are using.

Open a web browser and navigate to ​http://192.168.97.60/

Click "Browse..." and select the .bin file you downloaded earlier.
Click "Update firmware".

The firmware will now upgrade and the device will reboot, it might take a couple of minutes.
Note: The web browser will not tell when the upgrade is finished, so just close the browser.